QJB8070ZESTAW OSŁON, PÓŁOŻ NAPĘDOWA

Parametry

Kody EAN

Informacje producenta

Pic.1 Remove the road wheel and hub. Remove the old boot andclips. Clean any grease or debris from the shaft and joint.Pic. 2 Check fitting cone for sharp or rough areas. Smoothwith emery cloth if necessary. Spray outer with cone spray.Pic. 3 If fitting the new boot to an outer CV joint, turnthe boot inside out. (this will almost always be the case)Spray the inside with cone spray.Pic. 4 Place the large end of the boot over the narrow endof the cone. Place the large end of the cone over the joint.Pic.5 Push the boot forcefully until it is lear of the cone.Pic. 6 Remove the cone and turn the boot right side out - ifnecessary.Pic. 7 Snip the corner of the grease sachet and fill thejoint. Slide and stretch the boot into position over thejoint.Pic. 8 Secure the boot with fixing clips, removing anyexcess with tin snips. Replace the hub and road wheel.

Stosowane w produktach QUINTON HAZELL